API-1005 : Attribute(s) 'reportDate' specified in query parameters are not supported

Article Id: 5947
Status: Published
Updated On: 14-02-2018 08:10
Legacy Id: TEC1836169
Products:
CLARITY PPM FOR ITG CA Project & Portfolio Management CLARITY PPM FEDERAL CA Project & Portfolio Management SAAS STARTER PACK-CLARITY PPM
Issue/Introduction:

When you on every link on the New Interface main page, it appears the following error:

API-1005 : Attribute(s) 'reportDate' specified in query parameters are not supported 

Cause:

You don't have installed PMO Accelerator.

Environment:

All CA PPM versions from 15.1

Resolution:

Install PMO Accelerator.

The instructions are in the following link:

https://docops.ca.com/ca-ppm/15-1/en/add-ins-and-integrations/content-add-ins/pmo-accelerator/pmo-accelerator-add-in-setup/