PEPE FROM COMMAND INTERFACE After release upgrade

Products

• OM Spool

Issue/Introduction

After the upgrade from a previous release, the following errors are occurring when accessing the Spool menu:

PE FROM COMMAND INTERFACE

PEPE FROM COMMAND INTERFACE

Environment

Spool

Cause

There was a user library with an old ESFSSSM module in the STEPLIB concatenation of the Spool started task.

Resolution

Remove the old ESFSSSM module from the STEPLIB concatenation and follow the procedure below:

1) Issue the following command:

F caspoolstc,REINIT,MODULES,ON

Where caspoolstc is the name of the Spool started task

The following message should appear after this command is issued:

ESF888  REINIT MODULES PROCESSED - REFRESH PENDING

 

2) Stop and start the Spool started task.

The following message should appear during the restart:

ESF022  MODULE REFRESH PERFORMED   

 

Additional Information

A similar error may occur if maintenance is applied to OM Spool. Refer to the document below:

Error in Spool Menu after having applied maintenance: OPEN FAILED CODES: 'PEPE'