Uploading troubleshooting files from ProxySG to Symantec support using CLI


Article ID: 166518


Updated On:


Advanced Secure Gateway Software - ASG SG-300 SG-S500 SG-S400 Secure Web Gateway Virtual Appliance SG-S200 ProxySG Software - SGOS SWG VA-100


Steps to upload troubleshooting files from ProxySG to Symantec support using CLI.


If the GUI interface is not available, or you have command line interface only, you can upload the troubleshooting files to your case view by using the following. You will need to replace with the your case number.

PROXY_SG#config t
Enter configuration commands, one per line.  End with CTRL-Z.
PROXY_SG#(config diagnostics)service-info
PROXY_SG#(config service-info)view available
Service information that can be sent to case.
Name                                    Approx Size (bytes)
Event_log                               155,648
System_information                      Unknown
Snapshot_sysinfo                        Unknown
Snapshot_sysinfo_stats                  Unknown
PROXY_SG#(config service-info)send <case number>  Event_log
PROXY_SG#(config service-info)send <case number>  System_information
PROXY_SG#(config service-info)send <case number> Snapshot_sysinfo
PROXY_SG#(config service-info)send <case number> Snapshot_sysinfo_stats

Or you can upload the files using single command line:


PROXY_SG#(config service-info)send <case number> Event_log System_information  Snapshot_sysinfo Snapshot_sysinfo_stats