Time Synchronization Services test is failed after configuring NTP on an ESXi 8.0 U2
search cancel

Time Synchronization Services test is failed after configuring NTP on an ESXi 8.0 U2

book

Article ID: 372843

calendar_today

Updated On:

Products

VMware vSphere ESXi

Issue/Introduction

  • Performing Time Synchronization Services test from vSphere client via ESXi host>Configure>System>Time Configuration>Test Services gives warning as "Configuration is not working normally" after configuring NTP on an ESXi 8.0 U2

         

  • The test result in the following text area will show a message like the following example:

    Service analysis started on host: ExampleHost
    Test started at: YYYY-MM-DDThh:mm:ssZ
    Time Service is administratively enabled.
    Verifying NTP service.
    NTP server: ExampleIPAdress resolves IPv4: ExampleIPAddress
    Virtual NIC vmkX : Admin: Up
    IP Interface: vmkX IPv4 Address: STATIC ExampleIPAdress
    IP Interface: vmkX connected to 1XX on distributed vswitch
    IP Network Stack: defaultTcpipStack
    Firewall Rule: ntpClient allows traffic on port: 123
    Firewall Rule: ntpClient allows all IPs
    ntpd is running, PID: 2XXXXX
    Kernel clock type: ntp
    NTP is not synced
    NTP never was synchronized.
    Service analysis completed.

Environment

VMware vSphere ESXi 8.x

Cause

Post ESXi 8.0 Update 2 NTP client might reject certain server packets as poorly formatted or invalid. For example, if a server sends packets with a poll value of 0, the NTP client on ESXi does not synchronize with the server.

Resolution

This issue is fixed in ESXi 8.0 Update 3b, Build: 24280767. To download this build go to Broadcom Support Portal .
Release Notes: VMware ESXi 8.0 Update 3b Release Notes .

Additional Information