IM Connector Server Add failed: code 80

book

Article ID: 97594

calendar_today

Updated On:

Products

CA Identity Manager CA Identity Governance CA Identity Portal CA Identity Suite

Issue/Introduction

Symantec IGA (also known as CA Identity Manager) reports the following error when creating an Active Directory endpoint connection from CA Identity Manager (IDM).

Failed to execute CreateActiveDirectoryEndpoint. ERROR MESSAGE: Active Directory Endpoint 'AD_Sample' creation failed: Connector Server Add failed: code 80 (OTHER-NamingException): failed to add entry eTNamespaceName=ActiveDirectory,dc=im,dc=etasa: javax.naming.NamingException: The CCS Manager is not enabled and no remote server is configured for endpoint type 'ActiveDirectory' (ldaps://10.0.1.1:20411),

Cause

The connector server was installed without C++ connector server management.

Environment

Release: 12.x, 14.x
Component: Identity Manager and Identity Suite

Resolution

When installing the CA Identity Manager (IM) Connector Server you must install the Legacy Components (see screenshot below).  This will install both the JCS (Java Connector Server) and CCS (C++ Connector Server). 



The CCS is the legacy component which is required to connect with an Active Directory\ MS Exchange Endpoint.

After the installation is completed, please check that both the JCS and CCS services are running (see screen shot below).



Additional Information

If you have already installed the JCS without the CCS, run the repair function on the connector server setup.exe and install the C++ connector server, keeping all other settings the same. Once that is done, restart the services and everything should now work as expected.