XCOMU0297E Error requesting header confirmation: Txpi 227: Socket received 0 bytes
This error message can appear when doing a loopback transfer or sending files to these platforms after a new install. It usually indicates there is a problem with the TCPIP Configuration; in particular the inetd.conf file configuration.
If you still have the old Getting Started Guide for CA XCOM Data Transport for AIX, HP-UX (includes IA64), and Sun Solaris for r11, it has the incorrect path specified in the section Configuring TCP/IP from the Command Line where it describes updating the inetd.conf file.
To configure TCP/IP, follow these steps:
At the command line, verify that you are in superuser mode.
For all systems, use vi or another editor to update the configuration file /etc/inetd.conf with the following lines:
txpi stream tcp nowait root /opt/xcom/lib/xcomtcp xcomtcp REMOTE 0
txpis stream tcp nowait root /opt/xcom/lib/xcomtcp xcomtcp REMOTE 0 SSL
Note the following in the above commands:
* The argument following REMOTE is a zero.
* Each command must be entered on a single line.
For 11.6 SP01, please see Remote Session Control Parameters in the current manual.