Status Report task widget column adjustments for finish and start dates

Products

• Clarity PPM SaaS
• Clarity PPM On Premise

Issue/Introduction

The Finish [date] value is cutoff in the grid, and the task widget does not seem to properly auto-adjust the width of date columns to show the full date value (rather it cuts off the date values). How can you increase the column width of Finish to show the full date value? 

STEPS TO REPRODUCE: 

1. Adjust your browser zoom level to 100% or higher
2. In Settings, ensure your Date Display is set to the first radio option (mmm dd, yyyy versus mm/dd/yy)
3. Go to a project in Clarity
4. Ensure there is at least one task created on the project
5. Click on the Status module
6. Click Settings and check the check box for Tasks
7. Click Apply
8. Go to the Tasks section and view the Start and Finish date values

Expected Results: The full date appears for both the Start and Finish date fields (IE Aug, 31, 2021)

Actual Results: The dates are cut off and display with at least the last 3 digits cut off (IE Aug 31, 2…)

Cause

DE63257. This happens if your zoom level is 100% or higher.

Environment

Release : 16.0.0

Component : CLARITY PROJECT MANAGEMENT

Resolution

This issue was reviewed as DE63257 and due to the complexity of this defect, this issue is being tracked outside of a defect. It is currently under review. 

Workarounds:

1. Change the zoom level to a smaller size
   
   OR
   
   
2. Change your Date Display settings (Then the issue won't happen until your zoom is 150% or higher):
3. 1. Click on your avatar
   2. Click on Settings
   3. Click on General
   4. Change your Date Display settings to the right hand (smaller character length) option (mm/dd/yy)