ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
SDC TrapX filters not working as expected
Article ID: 226154
Updated On:
Products
CA Spectrum
DX NetOps
Issue/Introduction
The following filter was added to the trapX.config file:
filter * * * 6 9 1\.3\.6\.1\.4\.1\.6889\.2\.17\.1 forward 10.173.43.245:162
filter * * * 6 * 1\.3\.6\.1\.4\.1\.6889\.2\.17\.1 break
This should only allow this trap with a specific id of "9" to pass the filter.
However, traps with a specific id that starts with "9" like 92 or 936 also pass this filter.
The same occurs for any specific id.
Cause
Defect in the regexp filtering.
Environment
Release : 20.2.7/10.4.3
Component : Spectrum Trap Exploder
Resolution
This issue is addressed in the 10.04.03.D197 patch for Spectrum 20.2.7/10.4.3.
This issue will also be addressed in DX NetOps Spectrum 21.2.6.
Feedback
Yes
No
Powered by
