Gen and FarPoint TabPro OCX Installation

Products

• Gen
• Gen - Workstation Toolset

Issue/Introduction

How to install FarPoint TabPro OCX for use with Gen 8.6 Workstation Toolset?
Currently, it is the only supported Tab control with Gen.
See Gen™ 8.6 > Technical Requirements > General Comments section "ActiveX Controls and Web Generation"

Resolution

To place a FarPoint TabPro OCX on a GUI C Window, a complete licensed package needs to be installed.
The FarPoint TabPro Product Code and Serial Number are required for installation and can be acquired from [email protected] if needed.

The installation package can be downloaded using the following link: ComponentOne Trials > TabPro (tptrial.zip)
After downloading the zip file, run the enclosed setup.exe.

For additional questions about the FarPoint TabPro OCX, contact [email protected].