HyperTerminal settings to use to connect to the serial console
search cancel

HyperTerminal settings to use to connect to the serial console

book

Article ID: 167243

calendar_today

Updated On: 12-05-2024

Products

ProxyAV Software - AVOS Advanced Secure Gateway Software - ASG ProxySG Software - SGOS Content Analysis Software ASG-S400 CAS-S400 SG-S400 SG-S400-RP MC-S400-20 MAA-S400-10 ASG-S500 CAS-S500 MAA-S500 Reporter-S500 SG-S500 SG-S500-RP ASG-S200 CAS-S200 CAS-S200-A1 SG-S200 SG-S200-40 SG-S200-RP SSP-S210 PLATFORM SSP-S410 SSP SSP-S410 PLATFORM ISG Content Analysis ISG Proxy

Issue/Introduction

Connect to the serial console of your appliance using HyperTerminal.

Resolution

To connect to the serial console, use the following HyperTerminal settings:

  • BPS: 9600
  • Data bits: 8
  • Parity: none
  • Stop bits: 1
  • Flow Control: none