search cancel

UIM - How to configure the network monitoring usage and how the CDM probe fetches this data - IM - RAW


Article ID: 14871


Updated On:


DX Unified Infrastructure Management (Nimsoft / UIM)


This document can be used to configure Network Traffic Monitoring using CDM probe Raw configure option and the way the probe calculates the data using the probe on different environments (Windows, Unix).

Note: This document can only be used when you do not have an access to Admin Console as this feature is available through Admin Console. 

How to configure the network monitoring usage

How the CDM probe fetches the inbound/outbound/aggregated data


Any UIM version

CDM probe 6.30 or later


1.Open the CDM probe in Raw Configure



2.Click on “New Section” and make sure you check the “Create at root”.

        Provide the name “nic aggr” and Click on “OK”


3.Add the follow as a Key and Value to enable QOS.

         interval = 5 min

         qos_network_bytes_send_rate = yes

         qos_network_bytes_total_rate = yes

         qos_network_bytes_recv_rate = yes

4.Once we configured with above parameters, here is how the admin console maps.



5.In case if you would like to enable alarms, you may add the following fields also.


Note: You must add the threshold as per the requirement.


Additional Information


1558709276857000014871_sktwi1f5rjvs16rf5.jpeg get_app
1558709275084000014871_sktwi1f5rjvs16rf4.jpeg get_app
1558709273453000014871_sktwi1f5rjvs16rf3.jpeg get_app
1558709271694000014871_sktwi1f5rjvs16rf2.jpeg get_app
1558709269619000014871_sktwi1f5rjvs16rf1.jpeg get_app