Installing CA Top Secret 16.0 Using The ESD PAX Files Results In SMP/E GIM30206E Message.

book

Article ID: 14671

calendar_today

Updated On:

Products

CA Top Secret

Issue/Introduction

The native SMP/E (non-CSM) installation of CA Top Secret r16.0 may fail with the following error during the APPLY job in hlq.SAMPJCL(TSS5APP):

=======================================================================
GIM30206E ** APPLY PROCESSING FAILED FOR SYSMOD CAKOG00. HOLD REASON IDS WERE NOT RESOLVED.
GIM35901I    ?ERROR HOLD AC90345 WAS NOT RESOLVED.                           
GIM37001S ** APPLY PROCESSING STOPPED BECAUSE FUNCTION SYSMOD CAKOG00 FAILED.
=======================================================================

Environment

z/OS

Resolution

To avoid this SMP/E error, there are 2 options:

Option One
Modify the APPLY job to specify ‘BYPASS(HOLDSYSTEM,HOLDERROR(reason id))’:  

1) Run the APPLY CHECK job in hlq.SAMPJCL(TSS5APP), with the 'BYPASS(HOLDSYSTEM)' statement.
2) If run successfully, run the APPLY job in hlq.SAMPJCL(TSS5APP) with 'BYPASS(HOLDSYSTEM HOLDERR(AC90345))' .
3) If run successfully, run the ACCEPT job in hlq.SAMPJCL(TSS6ACC).
4) If run successfully, go to the 'Install the Maintenance' Section below and follow the instructions.

Option Two
Specify‘//SMPHOLD DD DUMMY’on the RECEIVE Job. After successful execution of the RECEIVE, execute the APPLY and ACCEPT jobs for the base product FMIDs:

1) Run the RECEIVE job in hlq.SAMPJCL(TSS4REC), but specify '//SMPHOLD DD DUMMY' .
2) If run successfully, run the APPLY CHECK job in hlq.SAMPJCL(TSS5APP).
3) If run successfully, run the APPLY job in hlq.SAMPJCL(TSS5APP).
4) If run successfully, run the ACCEPT job in hlq.SAMPJCL(TSS6ACC).
5) If run successfully, go to the ‘Install the Maintenance’ Section below and follow the instructions.

Install the Maintenance
Once the Base product FMIDs have been successfully ACCEPT'd, then the Maintenance RECEIVE and APPLY jobs can be run, using the Error HOLDDATA and PTF Maintenance File.
1.) If the Base product has been successfully installed, run the RECEIVE job in hlq.SAMPJCL(TSS7RECP).
2.) If run successfully, run the APPLY CHECK job in hlq.SAMPJCL(TSS8APPY).
3.) If run successfully, run the APPLY job in hlq.SAMPJCL(TSS8APPY).