ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

FTP download instructions

book

Article ID: 136357

calendar_today

Updated On:

Products

MICS Resource Management

Issue/Introduction

I have gone through the procedures to FTP CICS6840 and CIC6845 by cut / paste etc.. and getting an error '550 "File not found - access denied"


Environment

Release : 14.1 and 14.2

Component : MICS

Resolution

Note the JCL to download Mainframe Product Installation Files has you do a CD on the order # followed by the GET on the .bin file itself.



Download Methods and Locations


HTTPS via Browser

Broadcom/CA’s Product/Solution Download URL for HTTP and HTTPs are:

HTTPS - https://downloads.broadcom.com

ATTN: MIS/IT Department

To optimize downloads of products and solutions from Broadcom Support, configure the following additional URLs in your network security software and/or firewalls.

FTP - ftp://downloads.broadcom.com
HTTPShttps://downloads.broadcom.com

 

FTP Method

To download using FTP, the hostname is:

FTP - ftp://downloads.broadcom.com

After logging in, a list of order directories is available in the root directory.
You can use one of the input JCL samples to download an order:

JCL to Download ZIP file

//INPUT DD *
downloads.broadcom.com
[email protected] Password
bin
get <Order No>.zip /**your USS directory**/<Order No>.zip
quit

You can use the CAUNZIP utility to unzip the file and generate RECEIVE JCL.  See CAUNZIP requirements for instructions on using this utility

JCL to Download Mainframe Product Installation Files

//INPUT DD *
downloads.broadcom.com
[email protected] Password
bin
Cd <Order No>
get <filename>/**your USS directory**/<Order No>.zip
quit

JCL to Download PTF Solutions to Data Set

//INPUT DD *
downloads.broadcom.com
[email protected] Password
bin
Cd /<Order No>
locsite LR=80 REC=FB BLOCKSI=0
locsite PRI=50 SEC=10 CY
get <SolutionNumber.bin>  ‘yourDatasetName’ (REPLACE
quit

To find the PAX file or PTF number, hover over the order number.  The full pathname is not required.   Just specify the file name in the JCL.  For example, SO01234.bin or DVD0123456789.pax.Z.     

Sites that regulate access through an IP address will be required to allow network access to 141.202.253.110.





Additional Information

These instructions can be obtained at:



https://techdocs.broadcom.com/us/product-content/recommended-reading/product-related-technical-information/download-methods-and-locations.html?r=2