When managing HUB probe via IM installed on HUB server the configuration window crashes and does not allow any configuration of the HUB.
It does not revert to raw config it just crashes.
Installing IM on a standalone PC allows the hub to be configured
The application is crashing while updating the tunnel information in the UI.
After IM starts the hub configurator application(conf_hub.exe), the application sends a request(probe_config_get) to the controller on the hub to get the configuration information of the hub. It then parses the configuration sections and updates the UI controls.
In the failure logs, we have seen the application stops after getting the robots details from the hub.
Mar 8 12:26:00:886  hub: SREQUEST: getrobots ->XXX.XXX.XXX.XXX/48016
Use "Raw Configure" and set a valid date for the key "tunnel/server/notAfter".
notAfter = 1867325849
<Please see attached file for image>