search cancel

How to change the hub probe default port

book

Article ID: 10739

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

How to change the hub probe default port

 



Environment

Release: CNMSPP99000-8.47-Unified Infrastructure Mgmt-Server Pack-- On Prem
Component:

Resolution

1 - Backup the robot and hub folders 

 

(i.e. C:\Program Files (x86)\Nimsoft\robot) 

(i.e. C:\Program Files (x86)\Nimsoft\hub) 

 

2 - stop the 'Nimsoft Service Controller' running on the hub

 

3 - edit the hub.cfg (i.e. C:\Program Files (x86)\Nimsoft\hub). In the <hub> section, set or add: 

 

hubport = xxxxx

 

4 - now edit the robot.cfg (i.e. C:\Program Files (x86)\Nimsoft\robot ) set: 

 

hubport = xxxxx

 

5 - delete the hubs.sds and robot.sds from the hub folder (i.e. C:\Program Files (x86)\Nimsoft\hub) 

 

6 - start the 'Nimsoft Service Controller' running on the hub

Additional Information

UIM Ports Reference:

https://docops.ca.com/ca-unified-infrastructure-management/8-5/en/installing-ca-uim/pre-installation-planning/firewall-port-reference