Unable to access Adminconsole after upgrading to version 8.47

Products

• DX Infrastructure Management
• NIMSOFT PROBES

Issue/Introduction

After just upgraded the UIM from 8.31 to 8.47. 

Previously prior to upgrade, the adminconsole address was https://XX.XX.XX.XX/adminsole 

However  after upgrading to UIM 8.47 its https:// XX.XX.XX.XX:wasp-port/adminconsoleapp is available.

The version 8.31 UIM, the SSL was controlled by service_host probe.

Now version 8.47 UIM, the SSL is controlled by wasp probe. After deactivating service_host probe.

The web browser is able to reach https://xx.xx.xx.xx/adminconsoleapp.

The  service_host probe is no longer required for ver 8.47

 

Environment

Release: 8.4

Resolution

The address for Admin Console is now: 

• <UIM_Server_IP_Address>:<wasp_port>/adminconsoleapp

Note: The wasp port is set to 80 by default.

Additional Information

The new Admin Console provides an enhanced Raw Configure feature with the ability to search probe configuration files.

In previous releases, Admin Console used the service_host probe to communicate through the UIM bus.

This functionality now resides in a wasp probe deployed on the UIM server.

The service_host probe is no longer deployed in new CA UIM installations.