RO99650 - WBEM resource in RDT suddenly changing to USER0108
search cancel

RO99650 - WBEM resource in RDT suddenly changing to USER0108

book

Article ID: 97544

calendar_today

Updated On:

Products

Top Secret Top Secret - LDAP

Issue/Introduction

We already have WBEM defined in RDT and permitted to z/OSMF task and users. This fix overlays current WBEM resource in RDT and creates a new one, renaming old one into USER0108. This changes all of the permissions we have setup and breaks z/OSMF. XA USER0108= CIMSERV ACCESS = CONTROLĀ 

We already have WBEM defined in RDT and permitted to z/OSMF task and users. This fix overlays current WBEM resource in RDT and creates a new one, renaming old one into USER0108. This changes all of the permissions we have setup and breaks z/OSMF. XA USER0108= CIMSERV ACCESS = CONTROL What is a way to apply this required fix without affecting currently setup resources?

Environment

z/os

Resolution

There was a requirement to add POSIT=64 to this RDT class, due i believe an IBM change.
Once the fix is applied the ownership and permits will show with a class of USERxxx.
So unfortunately the ownership and permit's needed to be redone.

STEPS TO PERFORM *
1. LLA REFRESH and restart CA Top Secret with TSS,,,REINIT NOTE: the following messages will appear on the mvs console TSS9048I RDT SYNCHRONIZATION RENAMED WBEM USERxxxx DUE TO CONFLICT TSS9045I RDT SYNCHRONIZATION COMPLETE
2. Own the necessary resources via: TSS ADD(dept) WBEM(CIMSERV)
3. Permit access to CIM region control acid via: TSS PERMIT(CIMSERV) WBEM(CIMSERV) ACC(CONTROL)
4. Permit access to the users, for example, CIMUSR, via: TSS PERMIT(CIMUSR) WBEM(CIMSERV) ACC(READ)