Privacy Protocol field doesn’t show up in the SNMP Host Details Definition

Products

• NetMaster Network Automation
• SOLVE
• NetMaster Network Management for SNA
• NetMaster Network Management for TCP/IP
• NetMaster File Transfer Management

Issue/Introduction

The Privacy Protocol filed doesn’t show up in the SNMP Host Details Definition in the Netmaster region when running SNMPv3. As a result, it fails me from adding the privacy code. The snapshot of the panel will be attached later.

Environment

Release: SLOPFC00200-12.1-NetMaster-File Transfer Management
Component:

Cause

Fixes were applied to the *EXEC libries and/or LOAD library but the ++HOLD data was not implemented to copy updates from the *VSMI staging files to the VSAM files of the failing regions.

Resolution

This is general, not just for this instance:
When maintenance is applied that has ++HOLD requiring that an NMVIP job be run to copy data to VSAM, unexpected results will occur.

The easiest way to remedy this is to re-run the complete S0xLDVIP job from your region setup library to the Netmaster region with the proble. It will bring all VSAM files up to the latest available maintenance.

Alternatively, if you have one system that is working and another that is failing when both should be at the same level of maintenance, you can copy the PANLDIS, MODSDIS and OSCNTL (the last applies to Netmaster 12.1 and below) from the working system over to the problem system and it should also correct the problem.