When starting CA Intertest CICS r 10 using CAS9 do we require the SVC parameter in the CAS9 CAIRIM initialization as shown in the configuration manual?

Products

• InterTest - CICS
• InterTest - Batch
• InterTest VSE - CICS

Issue/Introduction

The client just installed CA Intertest CICS r 10 only. The configuration guide indicates that the SVC number is only required for CA Intertest Batch r 10 which the client is not licensed to use. But the example in the configuration guide shows the SVC number in the CAS9 CAIRIM parameter below. Since this is an CA Intertest CICS only install can I remove the SVC number PARM(220) from the CAIRIM card as shown below?
 
PRODUCT(CA INTERTEST/SYMDUMP) VERSION(VHB0) INIT(CAVHINIT)
 

Environment

Z/OS
CICS

Resolution

The SVC number is not required for CA Intertest CICS  r 10 only installs. Below is the CAS9 control card to be used.
PRODUCT(CA INTERTEST/SYMDUMP) VERSION(VHB0) INIT(CAVHINIT) 
 
If the client is licensed for both CA Intertest for CICS and CA Intertest batch Or just CA Intertest batch then the CAS9 control card would be
PRODUCT(CA INTERTEST/SYMDUMP) VERSION(VHB0) INIT(CAVHINIT) PARM(220)
 
Activating the product can be found in the CA Intertest and Symdump r 10 configuration guide.
Section Activate Your Product - CAIRIM