CAL2T056I every 30 seconds continuously when using iDash
Article ID: 94940
Updated On:
Products
CA 7 Workload Automation
Issue/Introduction
Why does the CAL2T056I message come out every 30 seconds the the CA 7 started task log?
CAL2T056I Session started (TERM0001) 00001/09010/111.222.33.4
CAL2T056I Session ended (TERM0001) 00001/09010/111.222.33.4
CA-7.SCMK - /CLOSE SUCCESSFUL FOR CTERM01
CA-7.822 - (CLINE01) CLOSED
Environment
Release:
Component: 7
Component: 7
Resolution
When running iDash, it will logon to CA 7 via the TCPIP interface every 30 seconds to get the schedule can values, by issuing command: /DISPLAY,PRINT=SCH
This is why you see the session starting and ended messages. This should not cause a problem with CA 7.
This is why you see the session starting and ended messages. This should not cause a problem with CA 7.
Feedback
Yes
No
Powered by
