D/S050E CA-ADAPTER SUBSYSTEM SADA IS NOT ACTIVE
Article ID: 94333
Updated On:
Products
TLMS Tape Management
Issue/Introduction
Receiving the following message upon launching the CA TLMS ISPF interface:
D/S050E CA-ADAPTER SUBSYSTEM SADA IS NOT ACTIVE
After installing CA TLMS 14.0, we received the following message upon launching the CA TLMS ISPF interface: D/S050E CA-ADAPTER SUBSYSTEM SADA IS NOT ACTIVE
Are we supposed to be running CA Adapter?
D/S050E CA-ADAPTER SUBSYSTEM SADA IS NOT ACTIVE
After installing CA TLMS 14.0, we received the following message upon launching the CA TLMS ISPF interface: D/S050E CA-ADAPTER SUBSYSTEM SADA IS NOT ACTIVE
Are we supposed to be running CA Adapter?
Environment
CA TLMS 14.0i
Resolution
We dropped support for System Adapter in CA TLMS 12.0, check the following:
1). There is a TASKLIB/STEPLIB within the TSO logon proc's that is still pointing back to an older release of TLMS.
2). The TLMS release in the LINKLST is pre TLMS 12.0 ahead of CA TLMS 14.0.
1). There is a TASKLIB/STEPLIB within the TSO logon proc's that is still pointing back to an older release of TLMS.
2). The TLMS release in the LINKLST is pre TLMS 12.0 ahead of CA TLMS 14.0.
Feedback
Yes
No
Powered by
