Error attempting to define the STC using IBM MFA 130 AZFEXEC
searchcancel
Error attempting to define the STC using IBM MFA 130 AZFEXEC
book
Article ID: 94106
calendar_today
Updated On: 05-02-2018
Products
ACF2ACF2 - DB2 OptionACF2 for zVMACF2 - z/OSACF2 - MISC
Issue/Introduction
We have installed the IBM MFA 130 software on an ACF2 system and are receiving the following error when attempting to define the STC using AZFEXEC:
No Factor-wide Data - You are unable to read the factor-wide data SAF RC=0x8, RACF RC=0xc, RACF Reason=0x4
AZFM106 Either the factor is not defined to RACF or you do not have permission to access it.
Explanation: The associated factor profile in the MFADEF class must be defined and take the name FACTOR.Factor-name. The profile IRR.RFACTOR.MFADEF.Factor-name must be defined in the FACILITY class and you must have appropriate access to this profile for the operation you are trying to perform.
User Response: Contact your security administrator.
Environment
IBM MFA / ACF2
Resolution
Verify that a CONTROL(FACTOR) record called AZFSTC has been inserted and ACTIVE. If missing insert one: ACF SET C(FAC) INSERT AZFSTC ACTIVE END
Refresh Facility record, F ACF2,REFRESH(FAC),T(FAC)
Once this is activated, try the AZFEXEC clist again.