Batch Command Interface causes error message N95703
Article ID: 92939
Updated On:
Products
SOLVE:Operations Automation
SOLVE:Access Session Management
SOLVE:FTS
SOLVE
Issue/Introduction
When you use BCI (the Batch Command Interface) you may get error Message
N95703 NO AVAILABLE SESSIONS (NO VTAM ACB'S) - RETRY LATER
when submitting the BCI-Job.
N95703 NO AVAILABLE SESSIONS (NO VTAM ACB'S) - RETRY LATER
when submitting the BCI-Job.
Environment
Release:
Component: SACCES
Component: SACCES
Resolution
Make sure that you specify an LUNAME or an LUPREF (LU Prefix) when issuing the BCILOGON command:
BCILOGON applname
USER userid{/password| PASSWORD password}
[MENU menu]
[LUNAME applid|LUPREF luprefix]
When the LUPREF operand is used, a three-digit number is appended to the LU prefix value. Initially that number is set to 001 and an attempt to open ACB luprefix001 is performed. If you do not specify the LUNAME and LUPREF operands, then an LUPREF of NMBCI is assumed. In any way, the ACB must be
accessible from the Netmaster Region.
BCILOGON applname
USER userid{/password| PASSWORD password}
[MENU menu]
[LUNAME applid|LUPREF luprefix]
When the LUPREF operand is used, a three-digit number is appended to the LU prefix value. Initially that number is set to 001 and an attempt to open ACB luprefix001 is performed. If you do not specify the LUNAME and LUPREF operands, then an LUPREF of NMBCI is assumed. In any way, the ACB must be
accessible from the Netmaster Region.
Feedback
Yes
No
Powered by
