How to change the RC/Migrator Analysis output PDS specification
search cancel

How to change the RC/Migrator Analysis output PDS specification

book

Article ID: 92875

calendar_today

Updated On:

Products

RC Compare for DB2 for z/OS

Issue/Introduction

The RC/Migrator for Db2 for z/OS (RCM) Migration Analysis panel displays the OUTPUT ANALYSIS SPECIFICATIONS section, which uses Managed Output.
How to switch to using a PDS for the Analysis Output.

Resolution

You can toggle between the two output specifications by typing an 'O' on the command line of the RC/M Migration Analysis panel.

COMMAND ===> o

'o' is an abbreviation of the OUTPUT line command which can also be used.

Alternatively you can set the default behavior to control the specification of the Analysis output, this is done via the RC/Migrator Profile parameters

On the RC/Migrator Main Menu

0 - Profile

Hit ENTER

2 - RC/Migrator Profile Variables

On the RC/M Global Operational Parameters panel

UPDATE OUTPUT SPECIFICATIONS ===> y

Hit ENTER

ANALYSIS OUTPUT TO PDS ===> Y

This sets the default to write the strategy analysis output to a PDS.