Suppressing Datacom message DB00248I
Article ID: 91920
Updated On:
Products
Issue/Introduction
Because there are so many DB00248I messages in my MUF log and on the console, can these be suppressed?
Resolution
These messages are deemed important and therefore, cannot be suppressed; however, the message is only produced one time for each module as it is loaded into memory.
The DB00248I messages contain vital information for use in troubleshooting any problem within the MUF, or with a DBUTLTY or DBSQLPR job. Since almost every problem will need to know the version of a module you have installed, these messages easily tell us what we need to know without having to run a separate SMP/E report and also a listing of the actual load module.
Additional Information
For more information about this message, please refer to the Datacom documentation for DB00248I message.
As always, please contact Broadcom support for Datacom if you have further questions.
Feedback
