search cancel

How to start the agent on OS/400 in a different jobq on AS/400

book

Article ID: 89630

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine

Issue/Introduction

How to start the agent on OS/400 in a different jobq on AS/400

Environment

Release: AOATAM99000-9.0-Automic-One Automation Tools-Application Manager
Component:

Resolution

Detailed Description and Symptoms

The strucagent command will submit a job call uc4agent in the default jobq of the user calling the command. Sometimes, it is necessary to have the agent start under a separate jobq in a different library.

 

Solution

?In 9.00A, there are two ways to start the OS/400 Agent. These are outlined in the documentation under Administration Guide, Installation, New Installation, Installation Procedure, Installing the Agents, Installing the Agent for OS/400 and then under steps 4 and 5.

 

I believe that the method that will accomplish what you are attempting is Method 1 where you can edit and compile UC4/CLLE(UCEX_RUN). Attached is a screenshot that shows what this can look like. This should allow you to edit what library and jobq the job runs in.