ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Activation Report displayed in pop-up when using AWI
Article ID: 88013
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
When executing a simple script in AWI with the following lines in the process tab:
The activation report will always be displayed in the pop-up instead of only showing the message for the input for the read command.
The report must be closed before entering the input for the read command and therefore before closing the pop-up.
N/A
When executing a simple script in AWI with the following lines in the process tab:
:print wieder ein Call
:READ &hugo,,,
:READ &hugo,,,
The activation report will always be displayed in the pop-up instead of only showing the message for the input for the read command.
<Please see attached file for image>
The report must be closed before entering the input for the read command and therefore before closing the pop-up.
Cause
Cause type:
By design
Root Cause: This is working as currently designed but will be re-designed in a future version.
By design
Root Cause: This is working as currently designed but will be re-designed in a future version.
Environment
OS Version: N/A
Resolution
At the moment this works as designed, however it will be re-designed in a future version.
Fix Status: No Fix
Fix Version(s):
N/A
Fix Status: No Fix
Fix Version(s):
N/A
Additional Information
Workaround :
N/A
N/A
Attachments
Feedback
Yes
No
Powered by
