Windows Agent's ini parameter "bindaddr" has no effect

book

Article ID: 87962

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine AUTOMIC WORKLOAD AUTOMATION

Issue/Introduction

Error Message :
N/A

In the ini file of a Windows Agent the parameter bindaddr= is configured.

After starting the Agent the SystemOverview in the UserInterface and Administration page in AWI shows a different IP address. 

In the Agent Logfile the Agent also comes up with the wrong IP address. 

Investigation

Example:
In the Windows- Agent ini file the following is entered:
bindaddr=192.168.248.1 
bindlocal=1 

However in the System Overview in the column "IP address" a different address (not the one defined) is displayed.

In the Logfile of the Agent, the Host Information also shows a different IP address then defined in the parameter bindaddr.
 

Cause

Cause type:
Defect
Root Cause: The Windows Agent did not send the value of the INI file parameter "bindaddr" to the Automation Engine.

Environment

OS: Windows
OS Version: N/A

Resolution

Update to a fix version listed below or a newer version if available.

Fix Status: Released

Fix Version(s):
Component(s): Windows Agent

Automation Engine 12.0.2 - Available

Additional Information

Workaround :
N/A