Report stuck in status "transferring"
Article ID: 87942
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
Report stuck in status "transferring"
Reports were not transferred correctly to the automation engine.
Further details regarding the behaviour/fix:
After an automatic restart of a job out of a workflow in combination with a limited queue, the report transfer has been initiated twice and resulted in different errors during the report transfer.
N/A
Report stuck in status "transferring"
Reports were not transferred correctly to the automation engine.
Further details regarding the behaviour/fix:
After an automatic restart of a job out of a workflow in combination with a limited queue, the report transfer has been initiated twice and resulted in different errors during the report transfer.
Environment
Release: AUTWAB99000-11.0-Automic Workload Automation-Base Edition
Component:
Component:
Cause
Cause type:
Defect
Root Cause: refer to description
Defect
Root Cause: refer to description
Resolution
This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.
Fix Version(s):
Automation.Engine 11.2.3 - Available
Automation.Engine 11.1.4 - Available
Fix Version(s):
Automation.Engine 11.2.3 - Available
Automation.Engine 11.1.4 - Available
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
