RSET in Post-Process shows different behavior after a restart
Article ID: 87749
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
n/a
If a variable with value "" (null) within a Post-Process / Post-Script of a task is inherited with RSET, the restart will cause that a blank is read out in Postscript out of the variable.
Value in Post-Process before of restart:
2016-04-14 13:23:55 - U00020206 Variable '&VAR#' was stored with value ''.
Value in Post-Process after restart:
2016-04-14 13:24:35 - U00020206 Variable '&VAR#' was stored with value ' '.
n/a
If a variable with value "" (null) within a Post-Process / Post-Script of a task is inherited with RSET, the restart will cause that a blank is read out in Postscript out of the variable.
Value in Post-Process before of restart:
2016-04-14 13:23:55 - U00020206 Variable '&VAR#' was stored with value ''.
Value in Post-Process after restart:
2016-04-14 13:24:35 - U00020206 Variable '&VAR#' was stored with value ' '.
Environment
Release: AUTWAB99000-11.0-Automic Workload Automation-Base Edition
Component:
Component:
Cause
Cause type:
Defect
Defect
Resolution
This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.
Fix Status: Released
Fix Version(s):
Automation.Engine 11.1.4 in AutomationEngine - already released
Automation.Engine 11.2.2 in AutomationEngine - already released
Fix Status: Released
Fix Version(s):
Automation.Engine 11.1.4 in AutomationEngine - already released
Automation.Engine 11.2.2 in AutomationEngine - already released
Additional Information
Workaround :
n/a
n/a
Feedback
Yes
No
Powered by
