ERT calculation via DB Load on command line ends with return code 1

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

Error Message :
N/A

When executing DB Load from the command line to update the estimated runtime calculation:

ucybdbld -I/opt/UC4/config/ucybdbld_INTE1.ini -B -LD -X/opt/UC4/utils/uc4-util/db/general/10.0/UC_UPD_ESTIMATE_ERT.TXT

The command aborts and ends without producing an error in the logs or traces.
It crashes. On the command line, the process produces a return code 1.

Environment

OS: Windows

Cause

Cause type:
Defect
Root Cause: DB Load fails to recalculate the expected run time (ERT).
When UC_UPD_ESTIMATE_ERT.TXT is passed to DB Load, the DB Load process ends with return code 1 without performing ERT calculations.

Resolution

This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.

Fix Status: Released

Fix Version(s):
Automation Engine 12.0.0 - Available
Automation Engine 11.2.3 - Available
Automation Engine 11.1.5 - Available
Automation Engine 10.0.8 HF 3 - Available

Additional Information

Workaround :
N/A