Unix Job that runs a simple ls command is running long
book
Article ID: 87673
calendar_today
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message : N\A
A Unix job that runs a simple ls command takes a long time to complete (eg: 2.5 minutes). The Automation Engine is running fine against all other Unix Agents.
Cause type: Configuration Root Cause: The \etc\hosts file contains an old IP address.
Resolution
This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.
Fix Status: No Fix
Additional Information
Workaround : Run the following command to check the processes created by automic ps -ef|grep automic If the address that it returns is an invalid IP address, then update the \etc\hosts file with the new IP address.