ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Unix agent fails to start with a Segmentation Fault Error
Article ID: 87601
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
[1]+ Segmentation fault ./ucxjlx6
FTP transfers files in ASCII mode by default.
When binaries (in an uncompressed file) are transferred in ASCII mode, it results in a "Segmentation Fault" error when staring the Unix agent manually.
Investigation
The error can be seen:
[1]+ Segmentation fault ./ucxjlx6
FTP transfers files in ASCII mode by default.
When binaries (in an uncompressed file) are transferred in ASCII mode, it results in a "Segmentation Fault" error when staring the Unix agent manually.
Investigation
The error can be seen:
- When Core dump is enabled, and a core dump file is created in the agent bin folder. The error will be in the core dump file.
- When starting the agent manually, with or without nohup.
Cause
Cause type:
Configuration
Root Cause: Transferring the files (FTP) in ASCII mode
Configuration
Root Cause: Transferring the files (FTP) in ASCII mode
Environment
Release: AUTWAB99000-11.0-Automic Workload Automation-Base Edition
Component:
Component:
Resolution
This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.
Fix Status: No Fix
Fix Status: No Fix
Additional Information
Workaround :
Transfer the files (FTP) in BINARY mode
Transfer the files (FTP) in BINARY mode
Feedback
Yes
No
Powered by
