Field of Pre-/Postcondition does not allow text input. Therefore "FINALLY Abort Signal:" cannot be added to Pre-/Postcondition.

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

Affects Release version(s): 11

Error Message :
N/A

Specific to ECC version 11.2.2: Saving a Post-Condition after adding: 
- CONDITION: "CHECK STATUS – IF task ended with status STATUS" 
- FINAL ACTION: "ABORT – Send Abort Signal:" because of error: "One or more parameters are not set." 

Reason: Adding Abort Text is not possible.

<Please see attached file for image>

Environment

OS Version: N/A

Cause

Cause type:
Defect
Root Cause: In the Workflow editor in the post condition the parameter for abort cannot be set.

Resolution

This field was added on 30/03/2017. This article has not been updated yet. Refer to the "Description" or "Workaround" sections for solution information.

Fix Status: Released

Fix Version(s):
Enterprise.Control.Center 11.2.3. – Available

Additional Information

Workaround :
(1) Java UI if you do not wish to upgrade to ECC 11.2.3; OR(2) Fixed with Enterprise.Control.Center 11.2.3