PSR3_ACTIVATE_REPORT Print Setting does not allow negative number
Article ID: 87481
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
U02011041 The value of the parameter 'LINE_COUNT' is not a number: '-65'
The SAP Agent rejects negative numbers for LINE_COUNT and LINE_SIZE SAP commands when performing the syntax check.
Example:
A negative number is not allowed in the PSR3_ACTIVATE_REPORT Print Settings.
U02011041 The value of the parameter 'LINE_COUNT' is not a number: '-65'
The SAP Agent rejects negative numbers for LINE_COUNT and LINE_SIZE SAP commands when performing the syntax check.
Example:
A negative number is not allowed in the PSR3_ACTIVATE_REPORT Print Settings.
Environment
OS Version: N/A
Cause
Cause type:
Defect
Root Cause: A syntax check rejects a negative number for an SAP command
Defect
Root Cause: A syntax check rejects a negative number for an SAP command
Resolution
Update to a fix version listed below or a newer version if available.
Fix Status: Released
Fix Version(s):
Automation Engine 12.0.0 - Available
Automation Engine 11.2.3 - Available
Fix Status: Released
Fix Version(s):
Automation Engine 12.0.0 - Available
Automation Engine 11.2.3 - Available
Additional Information
Workaround :
Predefine LINE-COUNT within the ABAP program as well as within a predefined job on SAP side which the gets duplicated for every execution
Predefine LINE-COUNT within the ABAP program as well as within a predefined job on SAP side which the gets duplicated for every execution
Feedback
Yes
No
Powered by
