Reorganizing one single client with DB Unload fails unless suppress_output=1 has been set

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

Error Message :
U00037131 Reorganizing one single client is only possible if the parameter suppress_output=1 has been set in the INI file.

The Release Notes of Automation Engine version 10 state the following:

"As of version 10, the INI-file parameters "reorg_mode=", "suppress_output=", "max_rt_number=" and "show_stats=" of the utility AE DB.Unload are meaningless.  The reason is that this utility now uses only the new deletion method."

However, reorganizing a single Client with DB Unload in batch mode will fail if the parameter suppress_output=1 is not set in the utility's ini file (ucybdbun.ini):
 

20170509/160753.300 - U00037131 Reorganizing one single client is only possible if the parameter suppress_output=1 has been set in the INI file.
20170509/160753.301 - U00037022 ABORTING due to error.

Environment

Release: AUTWAB99000-10.0-Automic Workload Automation-Base Edition
Component:

Cause

Cause type:
Defect
Root Cause: Need to remove references to obsolete ini parameters suppress_output and regorg_mode

Resolution

Update to a fix version listed below or a newer version if available.

DB Unload utility has been modified so it no longer requires the suppress_output=1 parameter to reorganize a single client.  In addition, all mentions of this parameter in the documentation have been removed.
 

Fix Status: Released

Fix Version(s):
Component(s) : DB Unload Utility

Automation Engine 12.1.0 - Available
Automation Engine 12.0.2 - Available

Additional Information

Workaround :
Edit DB Unload's ini file (ucybdbun.ini) and add suppress_output=1 in the [REORG] section.