Recurring execution with end date: auto forecast shows an unexpected result resp documentation is misleading.
book
Article ID: 87214
calendar_today
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message : N/A
A recurring execution is created, for example, every 30 minutes with an end date 21.10.2016.
Then the auto forecast is started and the result shows planned executions for the day. But the last entry is 21.10.2016 00:00.
For example, the end date means "beginning of the day" and not "end of the day". This is not described in the documentation.
Cause
Cause type: Defect Root Cause: A forecast of a periodic task doesn't calculate the correct end-time. If a specific end-date has been set for the periodic task, the forecast calculation ends before the end-date has been reached.
Environment
OS Version: N/A
Resolution
Refer to a fix version of the documentation listed below or a newer version if available where the documentation has been updated.
Fix Status: Released
Fix Version(s): Component(s): AE Documentation
Automation Engine 12.1.0 - Available Automation Engine 12.0.2 - Available