Impossible to create JC on DUAS v5.6 nodes
Article ID: 87192
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
N/A
It is impossible to create a JC that monitors DUAS v5.6 nodes since the Monitored Node Selection window does not show any nodes to select. This is a regression, this worked up to UVC v6.5.21.
N/A
It is impossible to create a JC that monitors DUAS v5.6 nodes since the Monitored Node Selection window does not show any nodes to select. This is a regression, this worked up to UVC v6.5.21.
Environment
OS: All
OS Version: N/A
OS Version: N/A
Cause
Cause type:
Defect
Root Cause: This was a regression introduced on Univiewer Console 6.6.01
Defect
Root Cause: This was a regression introduced on Univiewer Console 6.6.01
Resolution
Update to a fix version listed below or a newer version if available.
Fix Status: Released
Fix Version(s):
Component: Univiewer Console
Fix Version: Dollar Universe 6.8.21 - Available
Fix Status: Released
Fix Version(s):
Component: Univiewer Console
Fix Version: Dollar Universe 6.8.21 - Available
Additional Information
Workaround :
Using an Univiewer Console 6.5.21 or inferior.
Using an Univiewer Console 6.5.21 or inferior.
Feedback
Yes
No
Powered by
