Job chain does not display the correct date value
Article ID: 86568
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
There is no error message
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :When opening a job chain, it displays the 'start date' for all runs. If holds one of the run, then it will display the 'end date' instead.
There is no error message
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :When opening a job chain, it displays the 'start date' for all runs. If holds one of the run, then it will display the 'end date' instead.
Cause
Cause type:
By design
Root Cause: This is a normal behavior of Univiewer Console.
By design
Root Cause: This is a normal behavior of Univiewer Console.
Environment
OS: Windows Seven
Resolution
Because there is only one line for the date in the job chain graphic,it was decided to use the end date instead of start date for "Hold" uproc.
Fix Status: No Fix
Fix Status: No Fix
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
