Uproc is automatically "Force Completed" after having already Completed previously

Products

• CA Automic Dollar Universe

Issue/Introduction

Error Message :
The job log looks like below:
!================================================
_!**
$!** SESSION .... : SIG00001_S
$!** EXECUTION .. : 0000333
$!** PROCEDURE .. : GSCO16P100
$!** EXECUTION .. : 0003379
$!** M.U. ....... : U_ORACLE
_!================================================

03/15/2013 04:00:01 Start Condition Check
Processing Date 03/15/2013
03/15/2013 04:00:01 Submitted in BATCH Q: SYS_BATCH
under ENTRY N° : 003337
...
...
20130315040002 max control duration: setting limit date/hour to 20130315041502

03/15/2013 04:00:02 BATCH starting

03/15/2013 04:01:41 Start Completion Instructions
03/15/2013 04:01:41 *** NORMAL TASK COMPLETION ***
Session Number Uproc Number M.U. Aut.Proc.Dt Date Time E
SIG00001_S 0000319 GSCO16P100 0003244 U_ORACLE 100 14032013 14032013 040001 T

20130429040141 max. control duration: triggering force completion

04/29/2013 04:01:41 Start Completion Instructions
04/29/2013 04:01:41 *** NORMAL TASK COMPLETION ***
Session Numero Uproc Numero U.G. Aut.D.Trait Date Heure E

SIG00001_S 0000319 GSCO16P100 0003244 U_ORACLE 100 14032013 28042013 040158 T

*** NORMAL TASK COMPLETION ***
================================================================

Patch level detected:Dollar Universe 6.0.00
Product Version: Dollar.Universe 6.0.0
Uproc shows as executed without any scheduling or trigger. 
Due to "Time Control Management" parameters, the job was forced to completion again even after it has been completed.

Environment

OS: All
OS Version: All

Cause

Cause type:
Defect
Root Cause: This is a problem affecting Dollar Universe 6 until version 6.0.12

Resolution

Upgrade to Dollar Universe version 6.0.12 or a newer version if available.

Fix Status: Released

Fix Version(s):
Dollar.Universe 6.0.12

Additional Information

Workaround :
Modify the Time Control Parameters.