Ability to rerun a Multistep Uproc from specific step is missing.
Article ID: 86550
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
N/A
Patch level detected:Dollar Universe 6.3.00
Product Version: Dollar.Universe 6.3.01
Description :Ability to rerun a multistep SAP_XBP2 Uproc from specific step does no longer exist in V6.
When rerunning a SAP_XBP2 uproc from a specific step, the job runs from the 1st step defined in the uproc and executes all the steps.
N/A
Patch level detected:Dollar Universe 6.3.00
Product Version: Dollar.Universe 6.3.01
Description :Ability to rerun a multistep SAP_XBP2 Uproc from specific step does no longer exist in V6.
When rerunning a SAP_XBP2 uproc from a specific step, the job runs from the 1st step defined in the uproc and executes all the steps.
Environment
OS: All
Cause
Cause type:
Defect
Root Cause: In SAP Manager Version 4.4.1 it was possible to rerun a multistep XBP2 uprocs from a specifc step, by specifying the concerned step value in the Job creation panel.
This ability was available in V5 and could be activated by the variable U_STEP_TO_SAP set to Y.
This variable was missing in V6.
Defect
Root Cause: In SAP Manager Version 4.4.1 it was possible to rerun a multistep XBP2 uprocs from a specifc step, by specifying the concerned step value in the Job creation panel.
This ability was available in V5 and could be activated by the variable U_STEP_TO_SAP set to Y.
This variable was missing in V6.
Resolution
Update to the fix version listed below or a newer version if available.
Fix Status: Released
Fix Version(s):
Component: Application.Server
Version: Dollar.Universe 6.4.41
Fix Status: Released
Fix Version(s):
Component: Application.Server
Version: Dollar.Universe 6.4.41
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
