Opening multiple Job Chains at once results in opening new tabs instead of breadcrumbs

book

Article ID: 86279

calendar_today

Updated On:

Products

CA Automic Dollar Universe

Issue/Introduction

Error Message :
Pop-up error message from Univiewer Console:
##########################
On environment [UJCENT/UNIVIEWER/X]:
{1}
##########################

Patch level detected:Univiewer Console 4.0.00
When several Job Chains are opened at the same time (select all and press monitor), only one opens in the Job Chain tab as a breadcrumb and the rest open as a separate tab.

If you are in one of the separate tabs and for example, run a task, you would expect a breadcrumb to be opened at your current tab. But it opens the breadcrumb in only the Main Job Chain tab where you have a different Job Chain open.

When a job is executed it stays in the wrong Job Chain.

If you close the Main Job Chain tab but only leave separate Job Chains in tabs you can no longer run anything and It seems to try to find the main Job Chain tab which has been closed.

Cause

Cause type:
Defect
Root Cause: N/A

Environment

OS: All
OS Version: ALL OS

Resolution

Update to a fix version listed below or a newer version if available.

Fix Status: Released

Fix Version(s):
Univiewer Console v6.1.01 - Available

Additional Information

Workaround :
N/A