Unable to disable task via command line uxupd tsk
Article ID: 86265
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
N/A
Patch level detected:Dollar Universe 5.6.0
Product Version: Dollar.Universe 5 or DUAS 6 inferior to 6.1.21
Unable to disable task via command line uxupd tsk. After running the command, the task is still enabled..
From UVC, the task can be disabled.
N/A
Patch level detected:Dollar Universe 5.6.0
Product Version: Dollar.Universe 5 or DUAS 6 inferior to 6.1.21
Unable to disable task via command line uxupd tsk. After running the command, the task is still enabled..
From UVC, the task can be disabled.
Cause
Cause type:
Defect
Root Cause: Wrong syntax of the command uxupd tsk (missing techinf family before the argument DISABLE), the family parameter (techinf) should be compulsory.
Defect
Root Cause: Wrong syntax of the command uxupd tsk (missing techinf family before the argument DISABLE), the family parameter (techinf) should be compulsory.
Environment
OS: All
OS Version: All
OS Version: All
Resolution
Update to the fix version listed below or a newer version if available.
Since this version, if the argument TECHINF is not specified, the command will fail.
Fix Status: Released
Fix Version(s):
Component(s): Application Server
Dollar Universe 6.1.21 - Available
Since this version, if the argument TECHINF is not specified, the command will fail.
Fix Status: Released
Fix Version(s):
Component(s): Application Server
Dollar Universe 6.1.21 - Available
Additional Information
Workaround :
Fix the syntax of the command uxupd tsk, example:
$ uxupd TSK tsk=BUG35789 ses=BUG35789 upr=BUG35789 mu=FRSTL26DUPBA techinf disable
Fix the syntax of the command uxupd tsk, example:
$ uxupd TSK tsk=BUG35789 ses=BUG35789 upr=BUG35789 mu=FRSTL26DUPBA techinf disable
Feedback
Powered by
