Shift-ctrl key combination does not keep selection in the Job Run screen
Article ID: 86001
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
There is no error message
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :When selecting a large number of lines in the Job Runs, it's not possible to keep the selection with the SHIFT key because each time the Job Run screen is refreshed, the beginning of the selection is reset.
There is no error message
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :When selecting a large number of lines in the Job Runs, it's not possible to keep the selection with the SHIFT key because each time the Job Run screen is refreshed, the beginning of the selection is reset.
Environment
OS: All
OS Version: All
OS Version: All
Cause
Cause type:
By design
Root Cause: This is the normal behavior of the UniViewer Console
By design
Root Cause: This is the normal behavior of the UniViewer Console
Resolution
It's possible to make the selection easier by filtering first then selecting the lines by holding the SHIFT and CTRL keys at the same time.
Fix Status: No Fix
Fix Status: No Fix
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
