It is possible to modify the value of the uproc's variable while duplicating the uproc but before saving the duplicated uproc
Article ID: 85793
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
No error message.
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :It is possible to modify the value of the uproc's variable while duplicating the uproc but before saving the duplicated uproc. The following steps are used to reproduce the issue:
1. Create Uproc 1 with variable1 = 2
2. Duplicate Uproc 1 into Uproc 2 (Do not save at this point)
3. In Uproc 2, change the value of variable1 from 2 to 5. (variable1=5)
3. Save uproc 2.
You will notice that the value of variable1 will stay equal to 2 even after saving with the updated value
No error message.
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :It is possible to modify the value of the uproc's variable while duplicating the uproc but before saving the duplicated uproc. The following steps are used to reproduce the issue:
1. Create Uproc 1 with variable1 = 2
2. Duplicate Uproc 1 into Uproc 2 (Do not save at this point)
3. In Uproc 2, change the value of variable1 from 2 to 5. (variable1=5)
3. Save uproc 2.
You will notice that the value of variable1 will stay equal to 2 even after saving with the updated value
Cause
Cause type:
Defect
Root Cause: N/A
Defect
Root Cause: N/A
Environment
OS: All
OS Version: ALL OS
OS Version: ALL OS
Resolution
The issue has been fixed in Univiewer Console v4.0.16.
Fix Status: Released
Fix Version(s):
Component: Univiewer.Console
Version: Dollar.Universe 6.0.0
Fix Status: Released
Fix Version(s):
Component: Univiewer.Console
Version: Dollar.Universe 6.0.0
Additional Information
Workaround :
N/A
N/A
Feedback
Powered by
