Cannot relaunch a job and a popup error message appears
Article ID: 85579
Updated On:
Products
CA Automic Dollar Universe
Issue/Introduction
Error Message :
Popup error message:
##################
"could not update the launch. Reason: the begin date is after the original end date"
##################
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :The user re-runs a job but, with the default start and end date values, he gets an error message.
Popup error message:
##################
"could not update the launch. Reason: the begin date is after the original end date"
##################
Patch level detected:Univiewer Console 4.0.00
Product Version: Dollar.Universe 6.0.0
Description :The user re-runs a job but, with the default start and end date values, he gets an error message.
Cause
Cause type:
By design
Root Cause: This was done on purpose
By design
Root Cause: This was done on purpose
Environment
OS: All
OS Version: All
OS Version: All
Resolution
This is done by design in order to have the user to check before re-running a job run and to change the end date manually.
This is a higher security level in order to avoid duplicate launch of the same job during the same execution window.
Fix Status: No Fix
This is a higher security level in order to avoid duplicate launch of the same job during the same execution window.
Fix Status: No Fix
Additional Information
Workaround :
N/A
N/A
Feedback
Powered by
