ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Component Workflow selection window does not show full Workflow name in ARA and is not expandable
Article ID: 85119
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
The User Interface (UI) within ARA does not allow the user to resize the component workflow selection window.
If the user has long component workflow names, it is impossible to differentiate between the workflows when selecting as the names are cut-off at the end.
N/A
The User Interface (UI) within ARA does not allow the user to resize the component workflow selection window.
If the user has long component workflow names, it is impossible to differentiate between the workflows when selecting as the names are cut-off at the end.
Cause
Cause type:
Defect
Root Cause: The user interface does not allow the user to resize the component workflow selection screen and it is not wide enough to display the full component workflow name.
Defect
Root Cause: The user interface does not allow the user to resize the component workflow selection screen and it is not wide enough to display the full component workflow name.
Environment
OS Version: N/A
Resolution
Update to a fix version listed below or a newer version if available where the dialog for copying existing workflows within the component workflow selection screen has been made wider.
Fix Status: Released
Fix Version(s):
Automic Release Automation 11.2 - Available
Automic Web Interface 2.1.6 - Available
Fix Status: Released
Fix Version(s):
Automic Release Automation 11.2 - Available
Automic Web Interface 2.1.6 - Available
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
