Utilities fail with "Application return code = 1" when using start parameters from command line
Article ID: 84886
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
Application return code = 1
When running a utility from command line, it fails with the error "Applicatino return code = 1". Logs will only contain the utility's .ini but do not provide any further details.
Application return code = 1
When running a utility from command line, it fails with the error "Applicatino return code = 1". Logs will only contain the utility's .ini but do not provide any further details.
Environment
OS Version: N/A
Cause
Cause type:
Configuration
Root Cause: The program is failing due to incorrect start parameters.
Configuration
Root Cause: The program is failing due to incorrect start parameters.
Resolution
The utility is failing due to incorrect start parameters, and likely the hyphen characters, "-" are incorrect if the command was copied and pasted at any point.
Copying and pasting causes the hyphens to get confused between hard and soft hyphens, and deleting and then manually typing in the hyphens will solve the issue.
Fix Status: No Fix
Fix Version(s):
N/A
Copying and pasting causes the hyphens to get confused between hard and soft hyphens, and deleting and then manually typing in the hyphens will solve the issue.
Fix Status: No Fix
Fix Version(s):
N/A
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
