AH update not necessary when using ILM to execute DBUNLOAD utility to delete objects in recycle bin

Article Id: 84883

Status: Published

Updated On: 15-04-2018 08:02

Legacy Id: 000008928

Products:

CA Automic Workload Automation - Automation Engine , AUTOMIC WORKLOAD AUTOMATION

Issue/Introduction:

Error Message :
N/A

If ILM is in place an update AH for example:

U0003594 UCUDB Ret: '6' opcode: 'EXEC' SQL Stmnt: 'update AH set AH_DeleteFlag = ? where AH_OH_Idnr in (select OH_IDNR from OH where OH_DeleteFlag = ?)'

did not make any sense at all and was enhanced with this fix.

Now the DB Unload utility did not reorganizes table AH when ILM mode is activated.

Cause:

Cause type:
Other
Root Cause: If ILM is in place an update AH for example a message is displayed that doesn't indicate anything of value.

Environment:

Release: AUTWAB99000-11.0-Automic Workload Automation-Base Edition
Component:

Resolution:

Update to a fix version listed below or a newer version if available.

Fix Status: Released

Fix Version(s):
Component(s): Utilities

Automation Engine 11.2.2 - Available
Automation Engine 11.1.4 - Available
Automation Engine 10.0.8 HF2 -Available

Additional Information:

Workaround :
N/A