Command Sequence does not minimize properly.
Article ID: 84863
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
When attempting to minimize the command dialog windows, the windows themselves do not minimize, only the content inside. This leaves a large grey box present where the minimized version should occur.
N/A
When attempting to minimize the command dialog windows, the windows themselves do not minimize, only the content inside. This leaves a large grey box present where the minimized version should occur.
Environment
OS Version: N/A
Cause
Cause type:
Defect
Root Cause: Within an RA Job, if you attempt to minimize a command within the command sequence, the background panel stays large.
Defect
Root Cause: Within an RA Job, if you attempt to minimize a command within the command sequence, the background panel stays large.
Resolution
Update to a fix version listed below or a newer version if available.
Fix Status: Released
Fix Version(s):
RA FTP Solution 4.0.3 - Available
Fix Status: Released
Fix Version(s):
RA FTP Solution 4.0.3 - Available
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
